For assistance, please dial: 801.821.4411

I fried my top end and rebuilt it. Now it will not start. Replaced the coil, stator, crank seal behind the stator, been through about five spark plugs and even bypassed the oil injection and ran pre mixed gas. Stator is aligned properly, air/fuel screw is 1.5 turns out (tried 2 and 2.5 also) as recommended by service manual. Made sure throttle cable was adjusted properly because they have that stupid switch inside the case. Rebuilt carb as well even though fuel delivery was fine. There is no reeds on this bike and if there’s supposed to be there

To see the full content, share this page by clicking one of the buttons below

Polaris RZR Rentals