For assistance, please dial: 801.821.4411

I bought a set (40mm and 35mm) of bearing greasers from an Ebay seller. They are the over the axle style but the 40mm greaser won’t fit over my rear axle shafts. I removed the bearing carrier to do some other maintenance and the greaser does fit inside the bearing and works as advertised.

I measured the ID of the greaser with a caliper and found it be 1.15″.

The OD of the axle shaft is 1.18″ and they are the stock axles.

Anybody know what the OD should be?

The 35mm greaser

To see the full content, share this page by clicking one of the buttons below

Polaris RZR Rentals